Control Cable Sold in 3, 6, or 8 wire configurations. 3 wire turns the unit on and off at full output or at a factory set output level. 6 wire interfaces with a PLC for on/off and power control.  8 wire adds a process verification function by returning a signal which measure power in the output circuit.
	Foot Pedal Used for manual heating operations.  Depressing pedal turns the unit on at full power. Releasing the spring loaded pedal  turns off.  Also used with a timer power control or touch screen controller to initiate a cycle. (Recommended for heat times of 3 seconds or less)
	Twin Foot Pedal Used with a timer power control or touch screen controller to initiate a cycle. Depressing ON pedal starts the cycle.  Cycle will automatically time out unless the OFF pedal is depressed to end the cycle early.
	Power Control Foot Pedal Depressing the pedal slightly turns the unit on at low power. Works like the gas pedal on an automobile, full down is full power. Simply let up on the spring loaded pedal to reuce power and turn off.  Easy to use, intuitive heat control leaving the operators hands free.